 |
GeoLogika |
 |
 |
 |
|||||||||
Components
LN series laboratory plunger pumpsLN series laboratory plunger pumps are intended for the continuous process of liquid pumping without pressure fluctuations. The pump has two plungers and provides accurate and continuous liquid flow rate for any period of time. Details
LN1-500–1050 Large-Volume Plunger Pump for Laboratory NeedsLN1 - 500 – 1050 laboratory pump consists of one large-volume plunger. It is intended for continuous fluid supply without pressure fluctuations in applications where the necessary supply volume is limited and even minor fluctuations in flow rate or pressure due to switching between cylinders must be avoided. Details
LN1–1000 Automated Holding PumpAutomated holding pump is intended for the application and maintenance of pressure in hydraulic systems. The pump consists of one plunger and can continuously control fluid pressure in the system for an unlimited period of time. Details
Piston Oil/Gas ContainerThe containers are intended for the transportation and storage of oil and gas samples. Also, these containers are used in laboratory research to reduce the number of high-precision pumps and protect them from exposure to aggressive media. Details
Coreholder for the studies of electric properties of coreThe coreholders for the studies of electric properties of core are installed in systems for reservoir fluid filtration studies. The range of coreholders allows working with cores of up to 100mm in diameter and up to 1m long. Details
X-ray transparent coreholdersX-ray transparent coreholders are used in X-ray scanners and tomographs to study core saturation. There are different design versions to apply either 2D or 3D compression of core. Details
PIK-AEI-S Three-Phase Saturation X-Ray ScannerX-ray transparent coreholders are used in X-ray scanners and tomographs to study core saturation. There are different design versions to apply either 2D or 3D compression of core. Details
Cells for proppant conductivity studiesAPI-61 cell is intended for proppant conductivity studies. To perform a measurement, proppant is placed between the two planes of the cell. A cell modeling a fracture is placed in a hydraulic press. A prepared pre-heated liquid is pumped through the proppant pack. At a fixed compression of the pack, the following parameters are measured: pressure difference, flow rate and fracture width. Conductivity of the pack is determined according to Darsi law. Details
|
|||||||||||
 |
|
 |
|||||||||
